Discussion Locked

Xerox All In One Question

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Last week we had a power out and then on again withing a few seconds. My Xerox work center XK50cx has been reading the Black/Right ink cartidge as empty ever since. It was printing The cartridge is full or near full. I cleaned all the contacts on the cartridge and printer carefully but still no difference. Any suggestions or help would be appreciated.
Thanks

2 replies

by gsancataldo

Hmmm.
Possible you have been spiked. Have any of yor device settings retuned to the facory defaults? If so you should perform a full reset of your MFD to factory defaults and test again. This type of reset can only be performed from within the service mode of the device.

by howardroark

Thanks for your feedback! Yes that is possible. I don't see any problems with the device settings. It shows ok in device mgr and the interface comes up normal to the point where it hangs since it won't print when it reads the cartridge as empty. I uninstalled the printer driver and re-installed and no luck. I may try a new black cartridge? Seems to be at that connection that is the problem.

This discussion is closed to new replies.