Question Locked

Xp installation

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was installing windows xp, and while files copying to the partition , My computer freezed......
And when I restarted the computer, I got nth except that annoying sound, even the information of my cpu didn't apear... just a black page nothing written in it .....
What should I do ?

8 replies

by toivo talikka

Your CD may be damaged, check if it has some scratches underneath.

Your computer may have developed a problem. Did you select to do a full format of the hard disk in the beginning of the installation, or the Quick Format?

You can boot again from the CD and try to start the installation from the beginning.

by k19_widowmaker

I tried to boot from CD again, but as I told you, Nothing apears when I open the computer except The black page.......

by rschmid1

Was this operating correctly before you reloaded? Was the CD used a system CD from the PC vendor or a true XP Disk? Can you get to the BIOS?? or boot to the CD directly? The Black page = Black screen??? May have issues with video driver, or card died. Remove the vid cable and see if no signal message comes up on the screen (be sure the monitor is powered on)
If that happens, re-seat the vid card and boot to cd as the previous poster suggested format the entire drive before reloading the OS and you may want to scan the hard drive to check for bad sectors to figure out why the freeze during the last install.
If the machine is a dell there is usually a partition for troubleshooting that has a HDD scanner to check for drive failures in it.

Good luck

Ray

by k19_widowmaker

I can't get to bios, and it was a true XP disk.....
I guess that the problem is in my video card, but just want to be sure about sth, My C partition is formated and copying file to it while installing Xp was incompleted, in this case what must happend when I open my computer ? and what must happen when I open a computer with a broken Harddisk ?

by dan.cox

It sounds like a system board issue.
If you have a second computer you can try swapping out other parts such as memory and hard drive to ensure they are not the cause of the issue.
But it does sound like an issue with the system board.
If you can get it to go to bios you may want to use another PC to download the bios update and then try flashing the bios of the one that is faulty. If that doesn't work, replace the board.

by si6urd

I don't know what's wrong, but the last time I had my WinXP PC freezing and getting no respons at all on the screen after I turned off the PC and repeatedly tried to turn it on again, I left the on/off button on the front of my PC _on_, and then disconnected the power directly (in the back) and connected it again. Then the PC actually started up normally. You may not have that much luck, but it could be worth trying if you haven't already...

by geraldkiii

Try reseating all the connections on your system board. Pull the power supply cable from system board, reseat all media device cables and also pull the system batter (looks like a big watch battery). Once the connections are reseated and you pull the batter out and waited for a few minutes put the battery back in and plug the computer up and see if you can power on the device.

I bet that will work!

This discussion is closed to new replies.