Question Locked

bulid a home r small office network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have thrree systems in my office. how can i connect lan for three systems at one ip address. and iam using brod band for the internet. with 100.mbps speed. how can i connect the network and sharing for three systems.

3 replies

by oh smeg

You need to run CAT5 Cable over the office and connect all computers to a 4 Port Hub or Router and work from there.

If you have a 4 Port Router supplied by the ISP all that is required is to run CAT Cabling from that point to the remaining computers in the Office and then depending on what you want to achieve either just plug in and run the Network Setup Wizard to connect to the Internet or enable a Small Peer to Peer LAN.

If you only have the one connection on the ISP Provided Modem you can either run the Connection into one Computer and fit a second NIC Card and out through that to a 4 port Hub and then to the remaining computers in the office.

Or replace the ISP Supplied Router with a 4 Port Router and run the cable from there.

Or if the device you currently have supports it feed the Internet Connection out of the Modem to a 4 or 8 Port Hub to the Uplink Port on the Hub and then from the Hub to the computers.

Or if the ISP supplied Device has a WiFi connection fit Wireless devices to the computers in the office and run the networking Setup Wizard for Wireless connections.

Col

This discussion is closed to new replies.