Question Locked

ethernet driver

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

how to install the ethernet driver in redhat 9.
which driver is suitable for Intel 945gcnl mbd?

2 replies

by Former member

Installing Source RPM Package
=============================

The following are general guidelines for installing the driver. Refer to
DISTRIB.TXT for additional installation notes for various Linux distributions.

1. Install the source RPM package:

rpm -ivh bcm5700-.src.rpm

2. CD to the RPM path and build the binary driver for your kernel:

cd /usr/src/{redhat,OpenLinux,turbo,packages,rpm ..}

rpm -bb SPECS/bcm5700.spec

or

rpmbuild -bb SPECS/bcm5700.spec (for RPM version 4.x.x)

Note that the RPM path is different for different Linux distributions.

3. Install the newly built package (driver and man page):

rpm -ivh RPMS/i386/bcm5700-.i386.rpm

Note that the --force option is needed if installing on Red Hat 7.2, 7.3,
2.1AS and others that already contain an older version of the driver.

The driver will be installed in the following path:

2.2.x kernels:

/lib/modules//net/bcm5700.o

2.4.x kernels:

/lib/modules//kernel/drivers/net/bcm5700.o

2.4.x kernels with bcm5700 as an addon driver (e.g. Red Hat 7.3, 2.1AS):

/lib/modules//kernel/drivers/net/bcm/bcm5700.o

or

/lib/modules//kernel/drivers/addon/bcm5700/bcm5700.o

2.6.0 kernels:

/lib/modules//kernel/drivers/net/bcm5700.ko

4. Load the driver:

insmod bcm5700
or
modprobe bcm5700

If loading the driver on Red Hat 7.3, 2.1 AS or other newer kernels with the
tg3 driver, refer to the "Removing tg3 Driver" in DISTRIB.TXT before loading
the driver.

5. To configure network protocol and address, refer to various Linux
documentations.

Building Driver From TAR File
=============================

The following are general guidelines for installing the driver. Refer to
DISTRIB.TXT for additional installation notes for various Linux distributions.

1. Create a directory and extract the files:

tar xvzf bcm5700-.tar.gz

2. Build the driver bcm5700.o as a loadable module for the running kernel:

cd src
make

3. Test the driver by loading it:

insmod bcm5700.o
or
insmod bcm5700.ko (on 2.6.x kernels)

If loading the driver on Red Hat 7.3, 2.1 AS or other newer kernels with the
tg3 driver, refer to the "Removing tg3 Driver" in DISTRIB.TXT before loading
the driver.

4. Install the driver and man page:

make install

See RPM instructions above for the location of the installed driver.

5. To configure network protocol and address, refer to various Linux
documentations.
You have 2 different files available to you. So, which one you use is up to you. The instructions talk about using either one. If one doesn't work for you, try the other.
http://www.techsupportforum.com/alternative-computing/linux-support/19405-redhat-9-network-driver-installation.html

Please post back if you have any more problems or questions.

This discussion is closed to new replies.