Discussion Locked

Exchange 5.5 still relaying spam

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are having a problem with mail relaying. Our Exchange 5.5 installation is patched with service pack 4, and was so patched before the relaying began (about 1 week ago). We have followed the suggestions in articles on TechRepublic and the Microsoft Knowledge Base; we set to "do not reroute SMTP mail", and also tried routing just to our internal domain. The relaying continues, and, we are now blacklisted on several sites.

Microsoft's KB stated that, if you could apply the service packs and adjust the routing settings, then, registry changes did not need to be made. We made the changes through the routing tab, and, have not edited the registry.

Informed suggestions most welcome. This is a nasty situation and we are anxious to halt it.
Thank you.

5 replies

by maxwell edison

See this article titled, "Third-Party Mail Relay (Open Relay) and Microsoft Exchange Server". Not only will it provide you with the step by step instructions on configuring Internet Mail Connector to stop open relay, but will also give you some interesting insight into the open relay/spam issue.

http://rr.sans.org/email/open_relay.php

(REMOVE SPACES from the pasted URL.)

Maxwell

by maxwell edison

.
.
By the way, there are different steps required to disable open relay, depending on the version of service pack applied. See these links as well. They will provide some nicly illustrated instruction for both.

----------

Turning Relaying Off In Exchange 5.5 With Service Pack 2 Or Higher:

http://rr.sans.org/email/open_relay.php

----------

Without Service Pack 1 or 2:

http://support.microsoft.com/directory/article.asp?ID=KB;EN-US;Q193922&

----------

Microsoft article, "HOW TO: Prevent Exchange 2000 from Being Used as a Mail Relay in Windows 2000 (Q310380)"

http://support.microsoft.com/default.aspx?scid=kb;EN-US;q310380

(You've probably already seen this, but I'll post it anyway.)

----------

Good luck,

Maxwell

by srd

Thanks Maxwell! There was a setting in the SANS article not mentioned in the MSKB (and why not - it's their product!) which was the missing setup configuration for us, the rest having been done. Testing telnet EXCHANGE SERVER 25 brought the desired 550 response.

Appreciate your sharing your knowledge.
Sue

by srd

Thanks Maxwell, I have the appropriate article (from SANS, since we are at SP4) and the Exchange 2000 MSKB article you referenced, for our other mail server which is running Exch2K. I will let you know and, rate the answer after we check all and test. I appreciate your quick response very much.

Sue

This discussion is closed to new replies.