Question Locked

HP AiO 2575a has error: 0xc1ab0001

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Tried unplugging everything, checking printer head contacts, and
reinstalling drivers, etc. Can't find codes listed anywhere now (why did
HP remove that from their site?!?), so am at a loss as to what the
problem might be. Would hate to add to landfill...

4 replies

by rob miners

1. Make sure that:
a. Your HP All-in-One is plugged in and turned on.
b. The specified print cartridges are installed correctly.
c. The recommended paper is properly loaded in the input tray.

2. Reset your HP All-in-One:
a. Turn off the HP All-in-One by pressing the On button.
b. Unplug the power cord from the back of the HP All-in-One.
c. Plug the power cord back into the HP All-in-One.
d. Turn on the HP All-in-One by pressing the On button.

Disconnect the printer from the PC

Go to the Control Panel and click on Add/Remove Programs. Highlight any Printer Software that is listed here. Select Remove.


From the Control Panel, click on Printers & Faxes. Right click the printer in question and select Delete


Look at the Toolbar. Select File, then Server Properties. Look in the Drivers tab. Highlight the printers drivers listed here and click on Remove for each one.


Reboot the PC. Do NOT reconnect the printer!

Go to the website of your printer manufacturer. Look for new Drivers for your model. Download the correct software.


Run the exe file you just downloaded. It should auto-start the installation program


The software will tell you when to connect the printer.


Once the software is installed and the printer connected, Set the printer as the Default, try a test page.

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D

by Former member

Unplug the printer, hold the OK and Cancel buttons, and plug it back in. Hopefully it might reset it.

Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.

by thumbsup2

Could you post the whole error message please? We need to know which part is crashing. Is it SVCHOST or another module?

This discussion is closed to new replies.