Question Locked

pcanywhere forcing the modem to be unplugged

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an application that requires the use of com2 via dial-up to another machine. I also use pcanywhere to connect to the same machine for another purpose. The application and pcanywhere are not used at the same time.

The first application works fine UNTIL....I launch pcanywhere and subsequently close it. Once I do this, the first application will return an error that the modem is not online. The only way to resolve the issue is to uplug the modem and then plug it back in. The application works fine until the next time pcanywhere is launched.

The good news....I can repeat the problem every time. The bad news.....I'm not sure how to resolve it. Any assistance would be greatly appreciated.

Steps taken so far:
- Moved the modem from com2 to com4 - same issue. (something is on com3 already)
- changed the setting from com2 to USB - same issue
- added initialization strings to the modem properties - same issue
- reset modem parameters via mode.com after running pcanywhere - same issue.

Any thoughts would be greatly appreciated.

2 replies

by seanferd

Assuming this will help:

ATZ
or
ATZ# where # is the number of a profile, if the modem stores profiles. It seems like ATZ or ATZ0 (zero) would reset your modem to the default state that you use for the other application.

You would do this through the modem software's terminal. I think you can use Hyperterminal to talk to the modem if you have no UI software for it. Hyperterminal may be installed with Windows, and I believe you can still download it.

edit:
see "change the modem's port settings" & "test a modem using HyperTerminal" in the help file.

note that your modems exact commands may require spaces or ampersands, check with vendor information.

I dont think you can do this from the Windows command line any more, but if you can echo ATZ >com2 or something like that, you could save it as a cmd file.

This discussion is closed to new replies.