Question Locked

Texas Instruments: Yellow Prompt at Device Manager

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have reformatted a notebook and after installing all the drivers, there are still problems with Texas Instruments OHCI Compliant IEEE 1394 Host Controller and PCI-1410 Cardbus Controller... The effect was, LAN port and PCMCIA port doesn't function anymore.(BTW, those ports are functional before formatting). Please help me. Thank you.

4 replies

by older mycroft

Because the 1394 controller is for the Firewire connection.

Check your Network Adapter entry - that is what enables your LAN.

by tmalo627

But I just installed a firewire 800 PCI card on my custom built desktop (XP Pro SP2). In addition to the IEEE 1394 driver showing up in the device manager, it also created a VirtualBox Host-Only Ethernet Adapter and a Unibrain 1394 FireNet Adapter. I ran an IPCONFIG to see what was what. And in addition to my gigabit ethernet card that I use to connect to the network, the command prompt showed me two other interfaces, that were trying to obtain IP addresses. I disabled them in device manager because they were causing a conflict with me connecting to the internet.

by oh smeg

Or there are Device Conflicts occurring. So what are you told when you look at the Proprieties of these Nonfunctional Devices?

If the system doesn't tell you what they are you can find out by running the Unknown Device Identifier available here

http://www.zhangduo.com/udi.html

But if the system tells you what they are you need to look at things like DMA and IRQ Settings. ;)

Col

This discussion is closed to new replies.