Discussion Locked

Unable to send email out with exchange 5

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here is my problem. I setup an Exchange server 5.5 and I am able to receive mail from the internet but I can't send out. I have a Pix-506 firewall and I opened the proper ports. So when I send the mail out I receive an error stating
Your message did not reach some or all of the intended recipients. The recipient name is not recognized. Too many hops.
I hope someone has run into this problem. Please give me some ideas.

Thanks,
Will0863@aol.com

9 replies

by dynamo2003

When you say proper port do you mean SMTP messaging port? the error message can only mean that that the prot is open one-way. verify and try again.

by canucker

sounds like you may have a loop. run a trace from mail server to an internet address to ensure proper routing

by brasslet

"Too many hops" usually indicates a problem within the IMS setup, or possibly in your MX records.

I'd first take a look at the properties of your Internet Mail Service's Routing tab. Make sure you're specifying your e-mail domain(s) as inbound ifyou're rerouting mail. That's a common one. Post back if this doesn't help.

by marley1025

Here is my problem. I setup an Exchange server 5.5 and I am able to receive mail from the internet but I can't send out. I have a Pix-506 firewall and I opened the proper ports(smtp). So when I send the mail out I receive an error stating
Your message did not reach some or all of the intended recipients. The recipient name is not recognized.
I hope someone has run into this problem. Please give me some ideas.

Thanks,
Will0863@aol.com

This discussion is closed to new replies.