Actually, answer #1 is correct, but it needs to be done on the server, not the workstation:
Q297684
To resolve this behavior, use a command to change the default time-out period on the Windows NT Server 4.0 or Windows 2000 Server: At a command prompt, type: net config server /autodisconnect:30 .
The valid value range to configure this setting from a command line is from -1 through 65,535 minutes. To disable Autodisconnect, set it to -1 .
NOTE : This step must not be confused with the remote access Autodisconnect parameter that is turned off if you set it to a value of zero (0).
If you set Autodisconnect to zero (0), this setting is not turned off and after a few seconds of idle time very fast disconnections can occur.
For additional information about increasing the default time-out period, click the article numbers below to view the articles in the Microsoft Knowledge Base:
Q138365 How the Autodisconnect Works in Windows NT
Q128167 Server Service Configuration and Tuning