Question Locked

XP Home SP2/3 Hangs on boot Only with Dell Dimension 5100

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Software
- NLite Current release

- Disc 1
- XP Home SP2 OEM used disc

- Disc 2
- XP Home SP3 Slipstreamed from Disc 1 using NLite
- Has all hotfixes included
- no drivers
- Five Discs made from 1 ISO (ISO made from NLite)

- Disc 3
- XP Home SP3 Slipstreamed from Disc 1
- Includes all hotfixes
- Most Drives included for Dimension 5100

-Disc 4
- XP Home SP2 OEM Brand New Disc

Hardware
- Customer PC
- http://www.Tinyurl.com/Dimension5100
- Tech PC
- Intel Dual Core 2.3ghz
- 1gb ram
- Customer HDD as Primary Master
- Asus MB PXL5 (I think, i'm not at work to confirm)

- Situation 1
- Installed using Disc 2 on customer PC
- after installation and initial/first boot system hangs at windows load screen
- HDD tests reports no problems
- RAM tests show no problems
- Dell System Utility Test shows all systems functioning normarly and no problems (All Inclusive Hardware Test)
- Second installation with a secondary Disc 2 fails with some problem.
- installation on Tech PC using Disc 2 works, no boot problems. Reinstall to Customer PC and boot hangs.

- Situation 2
- Install on customer computer using Disc 1
- Installation does error once during install at the drivers portion.
- Upon reboot installation completes without further incident.
- Loads to windows screen and hangs.
- Installation using Disc 1 on tech pc installs without issues, installing HDD back to customer PC causes a hang at the windows xp screen.

- Situation 3
- Installation with Disc 3 again same as above it installs fine on tech pc, hangs on boot on customer pc
- to note, I made 2 discs with the customers drivers on it same results.

- Final Situation
- Installed using a brand new right out of the package XP Home SP2 OEM disc no issues installing right on the customers computer
- No hangs, no issues, all systems green.

I would like to know why something like this would happen? Any ideas? the only conclusion I can come up with is either

A) Bad Disc 1 consequently bad disc 2 and 3
B) Possibly the Service pack wasn't working with the hardware (found a forum string talking about xp file corruption after an upgrade? I'm not sure exactly waht the scf command line option does.

Also interesting notes:
1. It loads to safe mode and safe mode with command prompt (didn't try with networking) there was however no usb support so I couldn't do anything, the dimension didn't have a ps/2 port. and the computer power off switch does shutdown windows out of safemode
2. Safe mode with VGA causes the same issue as above, Hangs on boot.

2 replies

by thechas

If this system has a Prescott CPU, you may be running into the XP SP2 Prescott bug.

I went round and round with similar problems with a system several months ago.

Check with Dell for a BIOS update that corrects cache problems with SP2.

If Dell does not have a BIOS update for the specific system, then enter BIOS setup and disable the cache until you have SP2 installed and running along with updates.

What I ended up doing, was setting up the system with SP1, then installing SP3 to bypass the bug.

Here is a link to a discussion on the topic.

http://aumha.net/viewtopic.php?t=7447

Chas

This discussion is closed to new replies.