Question Locked

XP Proffessional Mouse not working, all drivers missing

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Please help me. My mouse drivers are missing, it doesnt matter what mouse I use, even a generic ps/2 nothing works! I have looked everywhere and downloaded all drivers I could find, and nothing works. in the device manager the mouse is missing, no listing for mouse or pointing hardware. before I re-install XP, id there anything I can do? Thanks for any help!

7 replies

by thechas

You can use the System File Check utility to search for and replace missing or corrupt Windows files. Search Help and Support from the Start Menu for SFC and you will have the instructions.

You can also perform a repair installation of XP. You boot from the CD and follow along like you are going to install XP. Then, when prompted, select repair.

For either of the above to work, you need to have an XP CD with the same service pack level as is installed on your system.

You may need to create a "slipstream" XP CD.

TR has a download that can walk you through the process.

That said, you might have a hardware problem rather than a driver issue.

Have you tried USB mice on multiple USB ports? And, have you had the USB mice connected when you booted up?

PS/2 ports can fail.
Windows may not use a mouse if the mouse is not present when Windows boots.

Chas

by yomalc

Thanks to all, I tried everything, still not working.
So after a little time re-installing xp, all is good! and working well!! still not sure what the original problem was, but I did have a few other issues, so re-installing the system was benificial.
Thanks again

by thechas

Just a guess, but I suspect that somehow the wrong chip-set driver was installed.

Could have been any number of other things though.

Wish you had told us about the other problems. We would have stepped back and taken a wider focus on the system.

Enjoy,

Chas

by oh smeg

If you have a M$ Branded Install Disc you can perform a In Place/Repair Install of XP by following the directions here.

http://support.microsoft.com/kb/315341

But be warned if you have XP Pro installed and are using the Windows Encrypted File System you first need to Backup your Encryption Key by following the directions here

http://support.microsoft.com/kb/241201

If you do not backup the Encryption Key it will be deleted when you repair the Window's Install and you will be unable to read or access any data on the HDD again.

Col

by emery60099

Sounds like your hardware is not working correctly. Try a USB port and make sure that PNP is turned on in your services. You could try to reinstall XP but if problem is still there it will be a new motherboard. Try USB.

by Former member

The port is dead. using the wrong ps/2 port (keyboard instead of mouse)
Does the keyboard work in safe mode? Is it USB? If it does, try removing the mouse in device manager while in safe mode. then restart with it connected.
In device manager what is listed under the [+]mouse? (safe mode)

Please post back if you have anymore problems or questions.

This discussion is closed to new replies.