Question Locked

802.11n on a Toshiba laptop?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Greetings all.

I have a couple of Toshiba laptops with the intel xxxxABG wireless chipset (one's mini-PCI the other's mini-PCIe).

I'm wondering if anyone has experimented with successfully ripping out their intel cards and replacing them with a drop-in 802.11BGN card.

Searching around I've found a few hints that mini-PCI and mini-PCIe cards are available, but the few pics of these cards I've seen appear to have the 3 antenna "n" setup whereby the laptop only has 2 antennae. Although technically very capable I'd sooner not have to dismantle the laptop/lcd to try to squeeze a 3rd antenna inside if it's even possible...

To cut a long story short - has anyone successfully dropped an "n" card (or found one that has 2 antennae connectors) into their toshiba (or any other mini-pci/e machine)?

Or do I need to go with yet another gadget hanging off my usb/pcmcia (God knows I could live without that) and simply disable the internal one?

TIA!

Bob

7 replies

by mgp2

While I've disassembled and reassembled several desktop units, I've never been brave enough to do the same with my laptop. I'm content to make do with the PCMCIA, which I'm doing. I'm rumming the D-Link DWA-652 as a companion to the D-Link DIR-655 router and I'm quite happy with this setup.

Good luck.

MGP

by langlier

because of the antenna issue. I've dismantled far too many laptops in my previous job and would have no desire to do so for something as simple as an antenna install... much better to purchase a PCMCIA card or Express Card or USB Card.

by older mycroft

And an absolute nightmare at worst.

The ONLY laptop I've ever had that runs as sweet as a nut is the ONLY one that hasn't had a visit from Dr Frankenstein!

Try 'Go-Faster Stripes' - they're easier to remove when you figure out they don't work.

by bob

Can only speak for myself, but when I started in electronics.... well... let's just say there were valves. And a computer was something you could stand inside. :-)

From an electronics/engineering background and having been in mainframe/mini/micro computing since the late 70's I kind of know my way around the inside of even the trickiest to open up of laptops.

On the subject of adding an antenna, the screen is usually very straightforward to open up and can be reassembled just as easily provided you've very careful removing the sticky or clip on parts (rubber bumpers, labels etc that usually obscure the screws.)

The route from the antennae cable, out past the hinges, is usually straightforward. *Maybe* you'd need to undo a hinge to get under or behind it. By the time you've removed the keyboard (again, hardly a technically challenging job) there's a good chance you already have access to everything you need.

Next comes the hardware. Genuine Toshiba spare parts, from one of their "n" enabled laptops should be able to source an antenna. The mini pci-e socket isn't proprietary, it's standard - so dropping in the Intel bgn card in place if an abg shouldn't be any headache.

Hardly a "Dr Frankenstein" job...

Wasn't asking because I didn't know how to do it, so much as out of curiosity if anyone's tried it...

In fact I'm sure the hardest part will be the laying on of hands, of a genuine Toshiba antenna/kit...

That, plus I wasn't sure if 3 antennae on an "n" is mandatory of if there are going to be cards that still take 2.

More than likely, if I can find the antenna and an Intel 'n' card, I'll be trying this little experiment out. Perhaps I'll post the results here with a how-to, a "DON'T TRY IT!", or any gotcha's.

Regards

Bob

This discussion is closed to new replies.