Discussion Locked

Asign a drive letter to a mounted drive?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

WINDOWS 2000 PRO

I just installed a new hard drive on my computer. I doing so, I cloned my old hard drive to the new one using Norton Ghost.

Some how my new hard drive wound up with an assignment of F: as the drive letter. When I attempt to chage this, using my the Disk Management tool it tells me "Cannot modify the drive letter of your system or boot volume."

Any help getting my hard drive back to the defaul C: would be most gratly apprecated.

Martin

5 replies

by estebandelatorre

I think that you instaled the new hard drive as a secondary, then ghost old hd into the new one, and then...
removed your old HD and let the new one be the primary right?
1.- Install the old hd and verify that it still working. Gather info about it's partitions.
2.- remove the old HD and install the new one. Remove all partitions and start creating the partitions as the old disk, also set the active partition and make it a bootable one.
3.- Install both HD, primary the old one and secondarythe new one. Create the image on the new HD
4.- Remove primary HD (old one) and set the new one as primary. Restore the image.
Good Luck

edt@bancobgn.com

by ins413

Do you still have your old drive? If you do, why not delete the new drive and repartition it. In a command prompt window within W2K, use xcopy c: d:*.* /s/c/h/e/r/k. This command will make an excat mirror of the drive. Shut down, remove the old drive and set the new drive as primary. This has always worked for me when switching or upgrading drives.

This discussion is closed to new replies.