Discussion Locked

Can get into Windows 98es full or in Saf

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Problem I can't not boot in windows 98es full or in Safe Mode too.
Any in DOS Mode. I can only get a black screen with (-) all the time
H.D. and BIOS is working OK ! and I booter from boot disk , did not work
How I get back in to windows???

11 replies

by dmiles

Check that memory modules are set in slot securely
and they are not bad

Check the graphics card,make sure it is working

Sounds like a hard drive problem that you mayn have to install into another machine to see if the drive is booting up

by thechas

If memory serves me well, the last peer who had this same problem, had a virus that rewrote his BIOS.

Just to be sure that I have this correct;
You cannot boot into windows at all.
You cannot boot up with a boot floppy.
After the PC completes the POST sequence, you get a blank screen with a (-).

If you are lucky, as soulrider said, your memory is loose in the socket, or failed.

Other hardware suspects include drive cables, and the reset CMOS jumper.

Can you enter BIOS setting?
Does everything appear normal for the P.O.S.T. sequence?
Does the computer hang just after POST, or do you get the screen that says you are loading windows, or the windows splash screen before the blank screen?

Chas

by ffontan1

YES this correct;
1)YES, I cannot boot into windows at all.
2)YES, I cannot boot up with a boot floppy.
3)YES, After the PC completes the POST sequence, IT CHECK HARDDRIVE, CD-ROM I get a blank screen with a (-).
4)YES I CHECK, Other hardware suspects include drive cables, and the reset CMOS jumper.

5)YES, I Can you enter BIOS setting?
6)Does everything appear normal for the P.O.S.T. sequence?, YES.
7)Does the computer hang just after POST,
8)NO, Wndows splash screen before the blank screen?,

by salochin

If it is ok, I would like to offer my thoughts that :-

1) You can probably boot to the A: prompt when using a GOOD boot disk. If not, try entering the BIOS and choosing to load 'SETUP DEFAULTS' and try again.

2) The problem appears to be caused by a corrupt MBR or corrupted SYSTEM files.

If you can perform point 1, make sure that you have FDISK.EXE and SYS.COM present (Win 98 version is required) on the disk. Firstly, type :-

FDISK /MBR

at the A: prompt (there is a space after the 'K'. The system should just come back to the prompt. Now type :-

SYS C:

at the prompt and you should get 'System files transfered'. Reboot the system and hopefully all should be resolved. The only outstanding thing is - what caused it in the first place?

It could be a virus or just an unusual corruption problem or even a tempremental hard drive but you'll need to monitor the situation.

by dgust

I have to say it sounds like a memory problem. If you have no screen display after the BIOS info displays on the screen the only things needed needed at this point are the drives and the memory. If the BIOS does not cycle the drives during the BIOS startup then the power supply or its connections to the drives seem suspect (perhaps a blown fuse). If the drives (floppy and hard drive) both cycle during the BIOS startup the power must be OK to them and it has to be a memory or motherboard failure. I would reseat the memory boards.

by ffontan1

04/24/02
Everything is working fine on the machine such as the Hardware. What I want to do is edit the registry in DOS.
"I have two errors in the Windows Registry that needs to be removed through DOS only", because at the present I can't get into Windows to fix.

This discussion is closed to new replies.