Question Locked

Can I System Restore blind? (Monitor driver corrupted)

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

installing Nvidia 7300GS ... Driver Problem so installed WMA driver from disc ... Installed car, ... New Card did not work. Put in original card (Standard Abit 128meg pci-E)

Now I have no monitor active at all ... Can I use the System Rstore "blind" ... as in ask for a restore point without a monitor

OR suggestions of how to get the Video Card working again.

Details: Setup Disc did warn that VGA drivers for that card (7300GS) were not compatible. I presumed it meant that the existing card was still in place... Anyway, after installing WMA Drivers monitor still worked fine... Reboot with new card in place, and ZILCH

Reinstall old card, still Nil Nitch Nada

Thanks

Michael

3 replies

by cg it

if you don't have a monitor during POST, then it's probable that there is a problem with the card. POST uses the BIOS vga driver so you have a display during POST which is before the O/S loads.

Your problem might be that your video card requires power other than that which it gets from the PCIe buss. Does your video card require power from the power supply ?

by harmonic12

Sorry to be so late replying ... Issue ended up being dirt in the Memory Chip slot. Completely unrelated to video cards. Cleaned up the Memory card and everything worked fine.

Makes little sense other than wiggling stuff triggered it off.

This discussion is closed to new replies.