Question Locked

Canon Imagerunner 7200 - screen not powering up or working

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

As simple as the title asks. It is a used copier acquired from a school that recently upgraded their copiers. It did work fine at the school. I have not been able to get it going since I installed it in my office.

The green power light on the panel does light up; I can hear a fan turn on and run when I power up the copier.

I purchased an exploded view-type manual to take it apart and verify all internal cables and such are attached appropriately.

Any chance there is someone out there that can help, or at least point me in the right direction to troubleshoot?

2 replies

by ---tk---

alot of the time those machines require it to be powered up for a few min before it can start working... b/c it needs a while to heat up certain parts... WOW, that is a beast of a printer (just looked it up)... I would look for error codes, if it doesn't give any then odds are... there isn't any...
If its a network printer, you will probably need to statically assign it an IP, and then map to the printer... and try from there...

This discussion is closed to new replies.