Discussion Locked

Compaq/Fujitsu Limited HDD software

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have the above type of drive, 68-pin,wide-ultra SCSI-3, u160 running on a SCSI adapter.Does anyone know any software that I can download to test for conditions.I find windows scandisk unreliable.

Many Thanks.

10 replies

by tduval

Always check your hard drive with scsi card constructor's bios.
On adaptec, Ctrl-A when prompted, and Check scsi disk.

by hop228

I see. It doesn't give you the option of Ctrl-A, instead Ctrl-D, which I have looked, but nothing to my interest,only setting up the card.

by hop228

I don't understand what you mean by "Always check your hard drive with scsi card constructor's bios."

The card I have is DPT PM2144W.

by tduval

This is an old Adaptec SCSI card.

During boot up, you can presse ctrl-a to enter bios, and then, scan drive, check drive or low level format drive.

by hop228

Yes, it is an old Adaptec SCSI card.

It has the option of Ctrl-D, all it has is options to set up the card, nothing on what you have mentioned.

by tduval

I'm sorry, but there's no way to find manual for your card in adaptec site.

If you have time, write all the options that are shown in your card bios, I'll try to find.

by hop228

Here are the DPT Configuration Utility upon pressing Ctrl-D

PCI Host Adapter Option Screen

HBA Serial number:47-010936, HBA Model:DPT PM2144W
07M1 (PCI HBA1)

PCI Parity Detect:Enabled
PCI Xfers/Brust:Auto
Extend PCI Req:Disabled
SCSI cmd queuing:Enabled
Scan delay (sec):default
EBDA Relocation:disabled
extended BIOS fns:enabled
boot order:normal
hba scsi id:7
termination:auto
termpower:enabled
scsi xfer rate:10mhz
ext. cable detect:disabled
ctrl-d message: enabled
dos/win3.1 cache:writethru
scam support:disabled

by tduval

Bad luck, you're into the scsi config, recent cards have another option (scsi utility) with detect, low level format, check drives...

Can't find any 3rd party software to test your disk.

Sorry

This discussion is closed to new replies.