General discussion

Locked

Conversion of Netware 5.0 Arcserve DAT t

By bulijr ·
I have about 70 DAT and DLT tapes that were written to using Arcserve for Netware with compression enabled. I have changed over all servers to NT and now I can not restore any data on the tapes into Arcseve for NT. Does anyone know how I can convert the tapes to be usable in NT. I heard rumors that there are places to get this done. My company would pay $100 per tape if necessary. Thanks for any help

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Conversion of Netware 5.0 Arcserve DAT t

by timber In reply to Conversion of Netware 5.0 ...

Don't know if you found a solution or not but if time permits setup a novell server restore the data copy it to a directory on the NT Server and back up the data on the same tape with NT Arcserve.

Sounds time consuming but it could definetally beworth it...

Collapse -

Conversion of Netware 5.0 Arcserve DAT t

by bulijr In reply to Conversion of Netware 5.0 ...

The question was auto-closed by TechRepublic

Collapse -

Conversion of Netware 5.0 Arcserve DAT t

by James_Randy In reply to Conversion of Netware 5.0 ...

If you are still tackling this problem, perhaps you should consider calling your local super-hero.

Collapse -

Conversion of Netware 5.0 Arcserve DAT t

by bulijr In reply to Conversion of Netware 5.0 ...

The question was auto-closed by TechRepublic

Collapse -

Conversion of Netware 5.0 Arcserve DAT t

by bulijr In reply to Conversion of Netware 5.0 ...

This question was auto closed due to inactivity

Back to Windows Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums