General discussion

Locked

Delay printing Dos Program (Clipper)

By Shanghai Sam ·
Why there is delay approximately 1 min printing through clipper program if print from the network? If i quit the program printing goes imediate.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Delay printing Dos Program (Clipper)

by sparent In reply to Delay printing Dos Progra ...

Sounds like your print queue is waiting for an End of Print Job (End of Capture?). It's been a while since I've dabbled with Netware but you can set certain parameters on your Netware print queues to control when jobs are released to the printer. I remember that exiting the program that initiated the printer would immediately send the end of job.

Collapse -

Delay printing Dos Program (Clipper)

by jereg In reply to Delay printing Dos Progra ...

please rate the question.

Collapse -

Delay printing Dos Program (Clipper)

by tjc In reply to Delay printing Dos Progra ...

Make sure you have the printer set to "print after first page" also make sure that you try turning off and ont he spool settings and see if you get any speed up. Also if this dont' help then please list what type of networka nd what type of printer you are using.

Back to Web Development Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums