Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Dell inspiron 2650 that I got as a hand me down for my oldest boy and it had a crashed HDD. I put in a new 80GB along with another 256mb ram in DIMM A and B and the bios is not recognizing HDD. From info I found on this great site earlier, I downloaded a new bios from A4 to A13, did not solve the problem. I then used the Dell Diag CD to detect and it did not. Any suggestions would be great!
3 replies
by jlstew Accepted solution
Clarifications
by computercookie Accepted solution
on their support page;
by oh smeg Accepted solution
It has a IDE HDD in it so what is the Jumper set to in this Drive.
As it is a NB Drive it should be set to Master not Cable Select or CS.
The other thing that can happen way too easily is that when you push the drive in the 2 rows of Pins are not plugged in quite often it is possible to push the drive onto the connector with just one row of pins going into the Socket and the other row either above or below the connector. When this happens the drive will not be recognized.
Col
This discussion is closed to new replies.
Trending Storage posts
Sort by Trending
Question Unanswered
cloud technology for education
0 helpful
0 replies
0 helpful
5 replies
Question Locked
Questions hdd new or used
0 helpful
5 replies
Question Locked
Questions hdds
0 helpful
2 replies
Question Locked
External SSD
0 helpful
6 replies