General discussion


Dell Latitude D600

By rprzybylow ·
I read in a thread on some post; I don't think it was here, that I could fix my problem with soldering a part back in place.

I have to push down real hard by the docking bad under the laptop inorder for it to boot up. Where is this part at? is there a wiring diagram? It's P@@SING me off.



This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

I don't have a clue

by OH Smeg In reply to Dell Latitude D600

But if you need to push on the Docking Station it is in there and ideally somewhere around where you are pushing, you would need to open the Docking Station and have a look for a Bad Solder Joint.

But here is the catch you need a Electronics Soldering Iron and Electronics Solder if you use anything else you will damage the circuit board and maybe render it useless.

As for Schematics Dell do not make these available if they exist at all so you are on your own there.


Back to Laptops Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums