General discussion

Locked

DIGITAL PICTURER TRANSFER TO PC/WIN98

By lancetheman ·
JVC CAMCORD WITH DIGITAL STILL PICTURE WILL NOT LOAD TO MY PC. INSTALLED SOFTWARE THAT CAME WITH CAMCORDER, BUT IT CAN'T SEEM TO FIND A COM PORT TO GO THROUGH. PC ONLY HAS 1 COM PORT AND i HOOKED UP THE CAMCORDER TO PC WITH IT. WHAT SHOULD I DO?
LANCE IN BEAUTIFUL HAWAII

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

DIGITAL PICTURER TRANSFER TO PC/WIN98

by Still_learning In reply to DIGITAL PICTURER TRANSFER ...

Set uup your modem to be Com2, then your camcorder should be able to install as Com1. Hope this helps.

Collapse -

DIGITAL PICTURER TRANSFER TO PC/WIN98

by lancetheman In reply to DIGITAL PICTURER TRANSFER ...

The question was auto-closed by TechRepublic

Collapse -

DIGITAL PICTURER TRANSFER TO PC/WIN98

by TheChas In reply to DIGITAL PICTURER TRANSFER ...

Start in system properties (right click on my computer) and verify that the COMM port is listed in the ports branch of device manager.

If not, you need to enter BIOS setup, and enable the comm port.
Many PCs are setup with the COMM port(s) disabled as most new hardware uses the USB port.

Chas

Collapse -

DIGITAL PICTURER TRANSFER TO PC/WIN98

by lancetheman In reply to DIGITAL PICTURER TRANSFER ...

The question was auto-closed by TechRepublic

Collapse -

DIGITAL PICTURER TRANSFER TO PC/WIN98

by lancetheman In reply to DIGITAL PICTURER TRANSFER ...

This question was auto closed due to inactivity

Back to Software Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums