Software

Ask something
Discussion Locked

DriveImage2002 - Broadcom NIC problems

0 helpful
3 replies

by grosero

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello, I have an XW4100 XPPro machine with the Broadcom NIC Carc built in...

I am having problems is loading the DriveImage 2002 software PC-DOS mode through the disks that I created through the Boot Disk Builder utility. When it load the Disk 2 it freezes in "Loading, Please wait...." section.

Thanks a lot..
Any suggestions...

GR

3 replies

by thechas

Are you booting from floppies when installing this software?

If so, the likely problem is that the hard drive is formatted as a NTFS volume.

DOS on it's own cannot access a NTFS drive.

At www.systeminternals.com you can get a utility to allow DOS to read a NTFS drive. I do not know if it would allow you to install the software.

Chas

by grosero

I solved the problem. I had to update BIOS, the Network Driver and the Chipset from Hp/Compaq site.

This discussion is closed to new replies.