Question Locked

Enable Gigabit Interfaces on Cisco ASA5510-SEC-BUN-K9

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

All--

According to the product description on Cisco's site ( http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/product_data_sheet0900aecd802930c5.html ) The ASA5510 with the security plus license has two gigabit interfaces and three fast ethernet interfaces (including the management interface). When I view the interfaces on this device though I only see the 5 fast ethernet interfaces. Am I doing something wrong or is the site incorrect?

4 replies

by synner

I believe you are interpreting the page incorrectly. You are reading table 7. Table 7 is a characteristics listing. If you read Table 13, you will see that by default, the ASA5510-SEC-BUN-K9 bundle comes with 5 fast ethernet interfaces. YOu may be able to install up to two Gig interfaces, but that's not included in the bundle.

by victor

Check out this page:
http://www.nettiki.com/?q=node/215

It mentions that the interface names remain the same for Ethernet0/0 and Ethernet0/1, but you can use the speed command to set it to 1000Mbps. I just applied the Security Plus License on our brand new ASA 5510 so I will try it out.

by rocky

I ran into this myself. Gigabit was introduced in 7.3(2). But it was left out of 8.0(2).

I cannot speak for 8.0(3) - but I know it works as stated in 8.0(4).

That is with a Security Plus licence you can configure "speed 1000" on e0/0 and e0/1 (it will autodetect it as well).

This discussion is closed to new replies.