Discussion Locked

Enough Power for a p4 2.53 gig, 7 fans

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a p4 2.53 gigaherz comp
SPECS:

p4 2.53 gig
512 DDR Ram
2 80 Gig Raid O Hard Drives
2 DVD+R drives
1 Floppy
1 PCI Sound Card
1 PCI MOdem
1 AGP gf4ti4200
added 7 FANS

I have it all connected to a 300 watt power supply. The question pertains to is that enough to get by? if so by how much?. I have a cathode i would like to put in, but wondering if im border, over, or still have some room?. The fans are 4 that are LED, 1 cpu fan, 2 top fans. Can you help?

RECAP:
New powersupply, or will the current 300 watt one work.

IM kinda wanting to stick to the current one due to warentee that i have already broken, don't want to go to much farter.

4 replies

by guruofdos

You really need 400w or 450 for the load you are using. If you read my previous discourses on power supplies, the absolute wattage is not really an issue. It's the current drain on the particular rail you are interested in. 300w must be split between 3.3v, 5v and 12v, but it may be that you are drawing a total of 300w or less but are exceeding the maximum permissible load on one rail...in your case, the 12v rail. Even a stick of DDR memory takes about 20 watts believe it or not, but that draws from the 3.3v rail. You have two hard drives, two CD's and a bunch of fans, which are all motor loads all drawing current from the 12v supply. If that little lot is drawing 20A peak (which is not unreasonable), i.e. on disk spin up, there is 240W on one rail (12v) for starters!!

by leehellcat

I think that with Power supplies being cheap as they are you would be wise to get a new one. a 550w if you can get hold of one, would see you through. They start at ?30 from local suppliers, so not massively expensive.
As for the warranty, if it's been broken alreasy, then keep going. As they say, once the flood gates break, the whole lot comes through eventually.

by thechas

I use 300 Watt supplies for ONLY entry level systems these days.

I heartily recommend that you go with at least a 400 Watt, if not a 500 Watt power supply.

Make sure that you get a true 400 Watts, I have seen a few 400 Watt supplies that actually have less rated capability than my favorite 300 Watt supply.

Chas

by guruofdos

Depends entirely on the max current per rail!

I have used 250w in systems supposedly needing 400W or higher because the current distribution between rails was better. No point in having a 400W supply if 240W of that is only available from the 12vline and you only have one fan on the CPU and one hard disk and no CD!

However, always calculate the actual loads per rail (drive manufacturers always quote these specs. Fans often have a current rating...amps x volts = watts). Aim for the capacity of the supply exceed your maximum calculated current by a factor of at least 1.33 to give you some headroom, then work backwards from there to choose your supply rating.

This discussion is closed to new replies.