General discussion

Locked

Error in Easy CD Creator 5

By caestelle ·
I have a user who everytime she burns a cd using Easy CD Creator 5 she gets the following three errors;

E80041898:Write error - [03/0C/00]
E80041934:TrackWriter error - Flush failed - [T7127]
E80041925:TrackWriter error - Command retry failed - [T711

-We get these errors no matter what speed we burn at.
-This is on a Windows 2000 system.
-I have already checked to make sure that all of the updates have been installed and I have done several complete uninstall and reinstalls of Easy CD Creator with the same result.

Any help is appreciated. THANKS!!

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by willcomp In reply to Error in Easy CD Creator ...

Most likely CD-RW drive failure if it has worked previously. If new installation, install Easy CD Creator updates and update drive firmware. If no success after updates, drive is highly suspect.

Collapse -

by OTL In reply to Error in Easy CD Creator ...

Not as familar with easy cd, however received the same type errors with Nero. Had to use Nero's CD drive testor (part of program) to tell the software what the drive was and data rate/burn speed capability.

Here is Roxio's fix for E800 errors (delete any added spaces).
http://www.roxio.com/en/support/kb/ecddvdc/ee6000019.jhtml

Collapse -

by abrouss In reply to Error in Easy CD Creator ...

I would defrag the hard drive first, then run adaware (get it from www.download.com) this is a pop up / spy ware blocker, then reboot and try to burn a cd before running any other programs.

the defragging my be the best help

good luck

Back to Software Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums