Community archive

Ask something
Discussion Locked

hardware conflict

0 helpful
1 reply

by tworeds2599

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE INSTALLED A IBM HARDWARE TO SCSI HOST,ITSAYS IT WILL NOT WORK BECAUSE MY HARD DISK CONTROLLER SHARES THE SAME IRQ.I HAVE TO DISABLE SOMETHING ELSE FOR HARDWARE TO WORK,BUT TROUBLESHOOTER CAN'T SUGGEST WHAT?ANY SUGGESTIONS?

1 reply

by gurnboy

Go into your bias setup and reassign the new hardrive a different irq ,or if you havn't, remove the old hardrive from your system in add/remove hardware.
Then after you have connected the new device turn off computer completely and do a fresh reboot

This discussion is closed to new replies.