Discussion Locked

Hdd showing corrupt volume label, un-typ

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On using the Fdisk facility to clear all partitions and re configure i made a new primary Dos partition and set it active. Now the volume label has some mad symbols on and i can't delete the partition as i can't enter the volume label??
Anyone out there fancy giving me a pointer???

Cheers
D.B.T

3 replies

by dkmc00

You can try reformating the disk using the Format command and create the partition again.

by djent

If its a SCSI drive use controller util and do a low level format. If its an IDE drive use Nortons wipedisk or ide_init to zero out the drive, either will wipe the drive to new condition.

This discussion is closed to new replies.