Discussion Locked

HELP! Can not get to DOS or C: Drive

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi

Yesterday I received responses to my question on how to install a new NT 40 BDC on a Member Server. ALL MY PATIONS ARE NTFS.

I went and did a NEW install (not an update) and it didn't work. I am now getting the error "missing ntosknl.exe,please install this fill" Well the problem is I can not get to a c: drive. I can not get past the logon screen, I can not boot to dos. HELP What other options do I have or is there a way to get around this? NOTE: This is on a raid server.

Thanks in advance

6 replies

by dmiles

Using the Setup disk you can reinstall the OS and do a repair install on the drive
To load DOS you will need the Win 98 startup disk and load dos,then load the WINNT operating system in NTFS which will be an extended partition so then you will havetwo partitions to format.

by wanabedrsean

I sent an email directly to you about this but I will post this so I can be rated. you may need to load a driver for the raid array controler this mabe why you cant see any drives if this server is a good brand eg compaq, or hp, etc. it came with acd or set of cds for compaq it is called smart start for hp it is called netserver navigator use these to do the install otherwise if you have a hardware raid you will need a driver for the array controller because nt only has a couple of them thatload automaticly during setup but it will alow you to specify additional storage drivers durring the setup process.

This discussion is closed to new replies.