Discussion Locked

HELP - I Can't Find My Hard Drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've been doing some work on a couple 98SE boxes I have. My current one has a primary master (OS & apps) and slave hard drive (stored files) and the second box has only a primary, (all Western Digs). I tried to move my slave to the other box....changed the jumpers, hooked in power & cables, but I can't see the icon in my windows interface. I looked in my CMOS/BIOS and it sees my primary 10 Gig & secondary 30 Gig, but no dice when I hit My Computer. I even tried "Adding New Hardware," but windows couldn't find it. I don't recall doing anything different than what I've tried in the past. I'm being told by others something is wrong with my drivers, but I thought I shouldn't have to add/change drivers with something so easy. Help me find my Hard Drive, PLEASE! All responses to ddyer21@yahoo.com.

7 replies

by opatzg9

If you run fdisk, what does it say about the second drive? Are they networked and is your first network drive f:? c,d,e your hard drives and cd? Is the cd drive hard coded to be d:? Just a few places to look. Did the 30 gig need drive mastering software to install on the other machine? Are the motherboards the same? Different chipsets may operate differently, you may wish to reinstall quickly in the old machine and make backups first, then try again with possible fdisk/format to initializeit into the new system. Good luck!

by thechas

Here is my guess as to what is going on.

I suspect that on the current system that you had to install Easy BIOS (part of the WD setup utilities) to allow that system to access large hard drives.
Or, you set up the drives with WD's utility disk, and it installed Easy BIOS or Data Lifeguard Tools for you.

With Easy BIOS, or DLGT, neither Windows or fdisk can see the formatted drive if the tools are not part of the boot sequence.

So, to see the drive on your second system, you either need to install DLGT on that system, or remove the tools an the primary system.

CAUTION: It is possible to LOOSE all data when un-installing Easy BIOS or DLGT.
Proceed with do caution!!!

Chas

by ctmoore1998

Boot to a DOS prompt (hold ctrl key just after poc to get boot menu and choose safe mode command prompt only. Can you change to the 'D' drive here and access the slave drive??? If not then your problem is still prewindows and you need to double check the MB to see that it supports > 8 or > 32 GB HHDs these are the 2 typical cutoff points. Also check that you don't have remode CD drivers loading and being labeled as the 'D' drive.
Check the CD-ROM drive settings in device manager Look at thedrive letter designation if possible move start letter (probably D) to a higher letter ie R and last letter can stay a Z then reboot and try again.

This discussion is closed to new replies.