Discussion Locked

How do i configur HP-UX Networks Line Pr

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can any body help me out configuring HP make Line Printer attached to HP-UX network and in the same Proximity I have windows NT network the problem is that I dont want to disturb the printer from unix Network but at the same time I want to use that printer as a Network Printer for my NT Network .

Can anybody help me ..

12 replies

by bowieb

I know that it's possible to setup a print queue in NT that will forward to the Unix printer, but I'm not sure how to set it up, but there is another way.

I have the exact same situation here in my office. What I do is run Samba on the HP-UX systems and share the printers directly from there. Samba is free software that allows the Unix system to share directories and printers as if it was a Windows system. It can even do authentication from your NT network.

You can get it from www.samba.org.

by rodperd

You can use SAMBA, but probaly you?ll "disturb" the printer on the unix network.

Try using the LPD/LPR service on NT server and none or minimal change will be required on HPUX.
First add "Microsoft TCPIP Printing service" (Control Panel/Network/Services) that comes with WINNT install CD, then add a LPR printer. Simple way to do this: open "Windows NT HELP" (Start/Help) and type "lpr" at index tab, select "To create a LPR cmpatible printer" step by step guide.

Hope this helps.

by Member 20529041

If you want to direct print to the network printer, it's easy.
Just make a entrance in /etc/hosts
map the printer to a hostname
(e.g 192.168.1.11 to hkpsvr01)
then in the printer setting page
add a remote printer (e.g hkgpr01) which the hosts is hkgprt01, printer is lp.
That done, try to print to printer hkgpr01.

by Member 20529041

Sorry Mistyping,
after add a line in /etc/hosts
(e.g 192.168.1.11 hkpsvr01)
then in SAM
add a remote printer
host is hkpsvr01, printer is lp
Try this

by jjaurigue

Try JetAdmin..

On our Network we config the HP printer on Unix first then we use JetAdmin to config for tht NT LAN

This discussion is closed to new replies.