Discussion Locked

How do you unstick VGA mode in Win ME?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My system was running fine until I changed the Processor. Windows ME was and is loaded new drivers for my ATI Rage 128 Pro AGP Video card are loaded but the system will not go to greater than 640x480 16 colors. I have tried a different video card with the same results. I have completely reloaded ME with the same results. I looks like I need to do some serious Registry Editing but where?

9 replies

by tbradley

In your system bios, under integrated peripherals, or video, make sure that AGP is selected as primary video card.

Completely remove the video card from your system settings and reboot. Does windows detect new hardware? Can you reload drivers atthis point?

If not, something has happened to your irq's.

remove the card from system settings, making sure that you also remove any "unkown" devices as well as adapters.

shut down the machine, and reboot, and go into safe mode. Again check the hardware settings, and remove any and all adapters and unknown devices, as well as extra monitors etc. I've seen systems with up to 20 extra monitors/adapters listed in safe mode....

reboot, and try loading again.

by dgup

Unacceptable is not really a good rating since I already tried all these things. And they each should have worked. I even went as far as using a different Video card and reset/deleted all the options and started over. I spent over 2 hours on the phone with Microsoft still not fixed! I believe the only fix is to adjust the operating system via the system registery or some how deleting it and starting over.

by tbradley

Did you go back to the original processor?

Did you shift from a true pentium to a celeron, or amd or ?

The problem could be in the differences in L1 and L2 cache between the processors.

If you did a complete reload ( not an upgrade or warm reload ), then the registry is not the problem.

by tbradley

also, in device manager, system settings some processors/chipsets have a processor to AGP
controller. You may have an incompatibility here if you've gone from a PII to a PIII etc.

doesn't hurt to check :)

by dgup

All of the suggestions or answers missed the mark and none worked. The solution that works but is pretty drastic is to rename the system.dat file and reinstall ME. This worked but many of the programs have to be reinstalled.

by tjc

How about wiping out the comptuer and reisntalling from scratch. Of course you will have to reinstall your programs and such.

by dgup

Actually this is probably the best answer but who in their right mind would reload Windows ME? ME would have to improve considerably just to SUCK!! I found the best answer was to rename the System.dat file and reinstalled the full video driver. This fixed the problem. I am replacing ME with 2k Pro.

This discussion is closed to new replies.