Discussion Locked

How to add IDE hdd to windows 2K ?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

when i connect an IDE hdd with win98 installed on it to Windows 2k professional.It gives following error
STOP: 0X0000007B (0xF081B84C, 0xC0000034, 0x00000000, 0x00000000)
If this is the first time you've seen this stop error screen, restart your computer.If this screen appears again, follow these steps:
Check for viruses......etc etc.

7 replies

by dmiles

The hard drive jumper configuration needs to be set for master and slave,see the diagram on drive to set W2K as the master and Win 98 as slave to your preference

Boot the system,at startup screen press key to enter Bios setup and see if the driveis being recognozed in the configuration,set the drives to Auto,depending on your computer make sure the Bios recognizes the size of hard drive,if not you will need to view the manufacturers web site for Bios update

by john tieso

Your problem is that WIN2000 cannot recognize or find the boot partition on the drive. Since WIn98 did not create a separate boot partition, WIN2K does not know what to do.

Either make this drive a slave drive (i.e. the physical 'D' Drive, or reformat it to allow WIN2K to read it as a data drive. As 'D' no boot partition is required.

by navjun

you need to make the new drive slave or Cable selecet (CS) then when pc boots goes to the win 2k OS and then sees the new HD.
thats all

This discussion is closed to new replies.