Discussion Locked

How to repair damaged start up files?

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Sometimes when I run Scan Disk, it says I have a damaged start up file that reports erroneous available disk space, but that it has repaired the file. Microsoft System Information says I have 337 MB of available space of 4102 MB(Fat32), but when I try to download a 150 MB file it says I do not have enough disk space. How do files get damaged? Is there a way to repair damaged start up files

1 reply

by thechas

The main way that files are damaged, is when the system hangs, or shuts down when the drive is writing to the file.
If you have W98, you may want to install the IDE cache supplement. This places a delay in the shutdown sequence to assure that the drive has completed any write cycles before the power is shut down.

Some files can be repaired using Sytem File Checker in W98, or XP (I don't know if it is in Me or W2K)

The reason that you are told that you don't have enough space for a 150MBfile, is because you realy don't have enough free space on the drive.
IE, (and most browsers) need a minimum of double the file size free in order to complete the download.
The file is downloaded into the internet cache, and then copied to the specified location.
In addition, while at a website, you increase the size of the swap file, and windows will always reserve some drive space to assure that you do not attempt to overfil the drive, and cause a crash.

Another factor is the size of your IE cache. It is limited to a % of free disk space, and if it is to small, you can't download the file either.

Chas

This discussion is closed to new replies.