Discussion Locked

How to revert to NT 4.0 PDC

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's a simple example of my layout:
1-NT4 BDC
1-W2K server with AD installed
Obviously I'm in peril and had planned on adding a second W2K DC, but there's a problem. Apparently accoring to Q260371 I have a disjointed namespace (if it sounds about as pleasant as a dislocated shoulder it is). Basically DNS is not going to work with the server in it's current config, no DNS no AD. The only known fix for the problem is the run DCPROMO and remove the DC making it a member server. In my casethat means domain is gonzo. I do have the nt4 BDC but I can't seem to promote it to a PDC using server manager, even with the W2K DC disconnected from the network.
Is there any hope for my Domain?
How can I revert to the NT4 as my PDC while I rebuild another W2K DC.

5 replies

by woody h

I am not too familiar with having both nt and 2000 on a domain, however, try using server manager on the BDC to synchronize with your primary DC. Once the synchonization is completed, remove the Primary DC. Wait about 10 minutes, then on the BDC in server manager, promote it to a primary DC. It will give you an error saying that if you continue, you will have a problem putting the PDC back online. In your case, you would not be planning on putting the original PDC back online. Click okay and allow it to continue. This should put your BDC to a PDC. I hope this helps. Good luck.

Woody

by mckaytech

I know this isn't a good answer but I'm not sure you can. One of the recommendations for preparation for a W2K migration is to build an extra BDC, allow it to syncronize and then take it off-line before the migration. I have been told that the rationale is that the AD installation alters the SAM structure of an on-line BDC so it can participate with the AD server in PDC emulation mode. If that is true, an on-line BDC may not be capable of promotion back to a PDC role and that might explain what you're seeing.

At this point, it seems like a tape restore of a pre-migration BDC or PDC might be the best option. But I hope someone else has a better answer!

paul

by Member 29279078

I think you are correct. I was able to promote it to a pdc but I could not get a new NT 4.0 bdc to recognize it as a nt4 pdc.

This discussion is closed to new replies.