Discussion Locked

How to use 2000 as router to send mails

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have 2000 server with ADSL connection and exchange 5.5 on the network. Is it possible to send mails through win2000 server which is configured as router.Can any body help how to configre this ??.

Regards,
Subhasha

5 replies

by curlergirl

The basic requirements and steps: You need to have a registered domain name and a static IP address. If you don't host your own DNS server(s), you need to make sure that your ISP adds an MX record for your server to their DNS server(s). You need to configure Exchange 5.5 by installing and configuring the Internet Mail Connector to connect to your ISP's DNS or backup mail server; and you need to configure each of your Exchange users' mailboxes with their SMTP email address - these addresses can be whatever your company chooses, but most companies will use something like [first initial][last name]@domain.com - for example, for user James Doohickey, the email address you enter would be jdoohickey@yourdomain.com. If you have a firewall or proxy server, there may be other steps in addition to these that are required to allow smtp packets to pass back and forth through the firewall or proxy, but that depends on what type of firewall or proxy you have and how it's configured. That's about it. Hope this helps!

by rotorman

If you have POP email then I would, for cost sake, just install a proxy server and route your email that way. Its very simple. I've used winproxy in the past very successfully. Its a cheap option than purchasing Exhange, have your ISP (which some charge $100 to do) configure MX records. Again, this option is really only good for small office (upto 20 users) setups!

This discussion is closed to new replies.