Question Locked

HP Pavilion Notebook DV 6000 Series Power Board Problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a Pavilion dv6129us. I dropped it a couple weeks ago, and the symptoms are just starting to show: the power button only works with a lot of pressure put on it. The power button LED doesn't light, and the speakers don't work. All these are connected to the same little board.

I have replaced the ribbon cable from the board - that was not the problem.

The board itself looks fine, but I'm not sure. The LED was lighting until a few days ago if I put a little pressure on the board area. Would anyone advise buying a new board (for only about $10) or could this be something else?

Thank you,
Charlie

4 replies

by Former member

Worse for you so if possible get a new board.

Please post back if you have anymore problems or questions.

by Former member

Since you have had the top off, look right under the power button and you will see a three prong connector. Check it. There were a lot of problems with this connector in the 6000/9000 series using the Apollo and Alantis MB's. (Quanta 3EB6, 3EB0, etc. Mb's)

If you are good with a soldering iron and understand multi level circuit board construction you can try to solder it yourself where the pins are loosend. If neither or only one applies, don't try it yourself because you will brick the machine.

by porrascarlos80

I have a problem also with a dv6000 I want to make sure is not the DC in jack. Anyone who can provide me voltages those cables out of the board should match?

When I connect my laptop, the DC In jack blue light, lights up and also does the wireless indicator but in orange color. Any Idea?

This discussion is closed to new replies.