Discussion Locked

I can't connect to the Internet with Win

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have DSL w/ a Linksys Router. There is a setting I am missing somewhere in Win2k. I run Dual-Boot 98/Win2k. I have no problems with the 98 configuration. Win2k nothing. Any and all suggestions would be helpful.

Thank You,
runemstr@linkline

9 replies

by thechas

The first thing to check is your installed network protocals, and their settings.

I would start by making sure that you have all of the same protocals in 2000 as are installed in 98.

Does your ISP require any different settings between the 2 versions of Windows?

Is the driver for the network card working properly in 2000? Conflicts here could also keep you from connecting to the router.

Are there other computers connected to the router?
If so, can you see them when in both Win 2000 and 98?

by runemstr

I have the exact same setings on both OS's. The ISP doesn't require settings for each different OS. All connections are tested and functioning properly.
No conflicts. Router can be seen on both OS's , but Win2K doesnt seem to get past the Router.

by misterit

I had dial-up problems with one of my ISPs when upgrading NT to Win2k. This probably only applies to dial-up connections, but anyways:

From connection properties -> Networking -> Type of dial-up server ->
Settings

deselect negotiate multi-link for single link connections.This setting helped me.

by rawright

Be sure that you have the default gateway on the Win2K PC's TCP/IP properties set to the LAN IP of your DSL router. I don't know the Linksys well, but it may need to be told the IP of the PC directly in order to respond. If you have the option to do so, you could also set the router to be the DHCP Server for your network, and set all PCs to obtain the connection info automatically.

by scottng2u

If u were not able to go online with windows 2k, you need to configure the following info to ur linksys router.

1. Go to dos, type in ipconfig /all
2. Printscreen the info out.
3. Go to your linksys router menu configuration, which is (http://192.168.1.1) and enter the password when prompted.
4. Click the setup page, and enter the information from the ipconfig printscreen.
5. Enter in the ip address of ur win2k, subnet mask, default gateway. If u don't have ur isp DNS ip address, go to http://allwhois.com and do a search on ur isp, then it should come back with ur isp DNS info, copy this info, and put in ur router.
6. After u have done this, click apply

7. The next step would be is to click on the DHCP, and enable it and click apply.
8. Click on advance TAB, and then click on FORWARDING.

9. Under the forwarding menu, open port 80~80 and enter in the ip address for ur win2k box that u have and click apply.

*** Verify that u have setup ur protocol correctly on ur win2kbox.
*** The most common problem is that the linksys will disable and block all pc from accessing the internet, if u don't have port 80 open from the router.

This discussion is closed to new replies.