Question Locked

Incorrect "New Hardware Found" messages on booting XP Pro

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm running XP Pro SP2 v.5.1.2600 on a Dell Pentium 4 3GHz with 1GB RAM.

Since I installed a USB joystick, every time I boot it up the system:

1) tells me in a pop-up on the Start bar that it's found a new device, (almost) correctly named

2) opens a dialog to install drivers, on which only the Cancel button is not greyed out

3) when I've cancelled #2, pops up another message to tell me that there have been problems with installation and the device may not work properly.

This sequence occurs each time I boot up, whether or not the joystick is connected to the PC. I should add that the joystick works perfectly when it is connected.

As you can imagine, this irritates me a lot. Any ideas on how to stop it?

4 replies

by computercookie

The USB driver may be corrrupt, try this;

Start > Control Panel > System, click on the hardware tab, click on device manager at the bottom you will see Universal Serial Bus Controllers.

This item should be expanded amd showing yellow exclamation marks to indicate a problem with a controller or hub. If you right click on these and select properties, you should be able to fix by clicking on the driver tab and selecting update driver if this fails to fix,uninstall and restart the computer and new drivers will be loaded.

by older mycroft

Ignore the box, leave it alone, don't touch it, go and make a soothing cup of your favourite beverage!

In other words, allow the system to 'timeout' with the popup still active. The system will kick-in and go off to find a suitable driver to facilitate this discovery of 'new hardware'.

I fear you may be the victim of your own impatience.

by hnmcc

All sorted out now, thanks to you!

This discussion is closed to new replies.