9 replies
by timwalsh
I'm assuming you are talking about increasing the amount of memory.
With an integrated card, there is usually no way to do this. Your only choice will be to disable the integrated video in the BIOS setup utility (if it will let you) and then purchase and install a card that will fit your computers bus architecture - i.e. PCI, ISA, VESA, etc. If this an older computer, you may be very limited with the cards available to work with it.
by computer-man
by dmiles
To increase the memory of the Video Card you will need to purchase naother video card that would be compatible with Windows 95 operating system
Yoou will want to check for Hardware Compatibility,which you may upgrade the board to a 16MB Graphics Card
The motherboard manual will list the option of using a AGP or PCI card,check to mke sure then your best option would be AGP
by computer-man
by alpha-male
Some integrated video cards will allow you to add memory into sockets on the system board to increase RAM. You may be able to go to 4mb by doing that (I'd be surprised if it offered more than that).
I would recommend you buy a new video card anddisable the one onboard. You should be able to do this in your BIOS or with a jumper. Check your motherboard manual if you are having difficulty.
Good luck! Hope this helps
by computer-man
by dmiles
The motherboard manual will need to be referenced to see what type of card can be installed in the system
There are two type s of slots on the computer PCI and AGP,
AGP was developed to give you better graphics and display.
Check the following sites for graphics cards
1)www.tomshardware.com
2)www.sharkyextreme.com.com/hardware/hardware_video.shtml
3)www.hardwarecentral.com/hardwarecentral/subjects/63/
4)www.pcguide.com/ref/video/
by computer-man
by computer-man
This discussion is closed to new replies.
Trending Software posts
Sort by Trending