Discussion Locked

Inserting a JPG in MS Publisher 2000

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

In MS Publisher 2000, I created and saved a brochure, which is 32k. When I insert a 257k JPG file into the brochure and save the same file, the size increases to over 19MB!!!!! Something in the exchange increases the publisher file to an unacceptable size. Try it!

I have access to MS Photo Editor, Adobe Acrobat & Quark Express to save JPG into different formats. Best I could do was change JPG to a GIF and drop it into publisher and save as a 6.5 MB publisher file. This is still too big.
Can anyone give me suggestions on ways to insert this picture and get the publisher file to a manageable size?

Thanks for helping.
FG

4 replies

by oz_media

I tried and tried and tried but couldn't get a file size over 1 meg. I added oversized graphics, high resolution graphics, photo's and still couldn't break 1 meg.

Your image is a 257kb jpeg, when it is inserted into Publisher, it is converted into a bitmap. If the ORIGINAL picture size (not the jpeg because that is compressed) is a large image, even after compressing it to jpeg, once inserted into Publisher it will become a LARGE bitmap.

Try taking your image and saving it as a bitmap (.bmp) file BEFORE inserting it, this will give you a more realistic idea of the file size. Adjust the Bitmap size and resolution to suit your needs (printable photo 600dpi, web or screen display 72dpi, standad printer outpu of general graphics 150-300 dpi). Inset the Bitmap instead of the jpeg and you should get a more accurate file size in relation to the original.

by oz_media

NOTE: A jpeg image is simply a compressed image. To see the REAL size, you must save as bitmap and check THAT file's size.

by fitgirl

I thought I had tried .bmp but I hadn't. After taking your advice, it dropped the .pub file size down to 870k which is much better.

Thank you,

Fitgirl

This discussion is closed to new replies.