Question Locked

Intel D845GVSR no access to keyboard during boot

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an Intel D845GVSR motherboard which I am trying to install xp on, the problem is when I boot it up and try to enter the bios settings I cannot select anything via keyboard it is not working, similarly if I try an boot from rescuse floppy I cannot continue because the keyboard is not active. I have tried serial and usb keyboards none work but, if I try and install ubuntu it will go so far and then stop at a command line then the keyboard is active?? I have tried the bios rescuse disc from intel and it works untill I have to press any key to continue. I have manually reset the bios but to no avail, I am alll out of ideas at this stage, any suggestions?

10 replies

by willcomp

Did you hot plug PS/2 keyboards or turn off PC before connecting?

by flemingwp

I would have thought that the usb keyboard would automatically be recognised when the bios post says usb support enabled?

by oh smeg

You have to use a PS2 Keyboard till after you install the OS. USB Keyboards require the USB Driver to be loaded and this requires a OS to load the USB Keyboard/Mouse Driver into.

Col

by willcomp

Yes, it should be if legacy USB keyboard support is enabled in BIOS setup. Have to disagree with Colin on this one.

by oh smeg

But with some of these 845 Chip Set M'Boards what should happen and what does actually happen are 2 different things when it comes to USB usability.

Some will only allow you to Boot off a USB Device when you set the USB to Legacy and not use a USB Keyboard/mouse while others will allow you to use a USB Keyboard/Mouse.

Just depends on the version number here of the actual Board in question.

Col

by flemingwp

So maybe the only other option really is to remove the bios chip and re-programme it then?

by oh smeg

You can Flash the BIOS with the newest Firmware available for your M'Board by downloading the BIOS Flash Utility and new BIOS File from the M'Board maker.

Or you can replace the BIOS Chip with one with the latest BIOS by buying one from here I always buy new BIOS Chips for Servers as Down Time is way to expensive for the companies and it's not worth the risk of a BIOS Flash going bad.

http://www.biosman.com/

However if it is something like an older version M'Board you need to remember that different Revisions can have different circuity involved. This can be done to make better use of existing features of the Chip Set and isn't backward compatible. Basically you have to live with what you have and work within it's limits. A PS2 Keyboard will not cost you more than $9.00 AU and it's not worth messing around trying to make something that doesn't want to work work.

Col

by flemingwp

Hi Col,
Thanks for the advice, the problem even with flashing from floppy or cd is I still need an active keyboard to continue with that process, I have flashed serveral bios chips with an eprom programmer I have.., although I have never unsoldered a bios before, I like a challenge.., the board in question is not a critical component so nothing will be affected by it been out of action at the moment.. I am pretty convinced it is a bios issue though.

by oh smeg

One without an Earthed Tip and preferably Temperature controlled to something like 312C. Solder melts at 310C so a couple of Degrees more but not any more than that will give you enough heat reserves to do the job safely.

Also use Electronics Solder the thin stuff with a High Silver content and you should be OK.

Col

This discussion is closed to new replies.