Question Locked

Internet problem on Lan port of AP

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello there,
I have a DSL line via wireless modem/router at my home.

What I would like to do is (if possible), connect a NAS disk to the ethernet port of a wireless AP, and have access to this disk via internet.

The problem is, I can not get any internet through the lan port of the AP.

I guess the AP and my modem/router are set correctly from what I read from manuals and several forums (at least about "meshing" stuff). I have "wireless" access to the internet from the AP but not through Lan port!

I would also like to give some details about my current configuration because I believe the answer lies somewhere here:
My router and AP are using different IP pools.

Modem/Router:
DHCP: active (193.168.2.2 - 254)
Subnet: 255.255.255.0
Gateway: 193.168.2.1
AP:
DHCP: disabled
IP pool: 192.168.40.2 - 254
Sub:255.255.255.0
Gateway:192.168.40.1

I'll appreciate any comment. Thanks.

6 replies

by arujammer

From the configuration i see that your using different subnets (193.168.2.0 and 192.168.40.0)
Try changing your AP Gateway to 193.168.2.1

by kayali

First I need to say that I'm not an IT expert so please do not get me wrong.
I'm a bit confused about your solution.
If I set the AP gateway to 193.168.2.1 (which is same with modem/router's) how will I get access to configuration pages of AP or modem/router via browser? Shouldn't they be different?
Also as I said in my first post, there is no connection problem wirelessly! I have internet through AP using wifi. If gateway or subnet were the problem, shouldn't I also have a problem via wifi?

by arujammer

I though it was your network setting.

Which product of AP are you using?

Seems like the LAN interface settings are not correct.

by kayali

Followin the suggestion of using same subsets,

I managed to have access from the lan port by changing the ip settings of the Access Point.

I assigned a static ip of 193.168.2.10 to the AP and sset the default gateway as 193.168.2.1 (which is my modem/router's gateway).

Now with no problem the ethernet port of AP is running.

FYI

This discussion is closed to new replies.