Discussion Locked

Mirrored drive recovery after MB failure

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Situation:
The motherboard failed on a Windows 2000 Server computer with the boot volume mirrored. After replacing the motherboard and trying to boot the computer, I get the following ...
STOP: 0x0000007B (0xF741F84C,0xC0000034,0x00000000,0x00000000) INACCESSIBLE_BOOT-DEVICE
How can I get this mirrored volume to boot normally without loosing data?

4 replies

by curlergirl

Here's a KB article that may be of some help - it refers to moving a Win2K installation to new hardware - which is essentially what you have done by replacing your motherboard: Q271965. If that doesn't help, there are a lot of other articles in the KB about this issue - go to www.microsoft.com/technet and search for "Stop 0x7b". I got quite a few hits. Hope this helps!

by shanghai sam

Thank you. This will help me in the future, but not for my immediate problem. The motherboard that went bad is not available, so I replaced it with a different one. If there is a way to merge the PNP ID of the new board into the Windows registry of the mirrored set that will not boot, I would like to know it. As of yet, I am forced to load another drive with Windows 2000 Server to be used as the boot volume and use this mirrored set as secondary.

Thanks again.

by mattp

Here is the cause:

The registry entries and drivers for the mass storage controller hardware in the backup computer are not installed in Windows.

For integrated device electronics (IDE) controllers, there are several different chip sets available, such as Intel, VIA, and Promise. Each chip set uses a different Plug-n-Play (PNP) ID to identify it.

The PNP-ID information of mass storage controllers for the backup computer must be in the registry prior to startup for Windows to initialize the correct drivers.

For resolution try here:
http://support.microsoft.com/search/preview.aspx?scid=kb;en-us;Q271965

AND

http://support.microsoft.com/default.aspx?scid=kb;en-us;Q249694

Good Luck

by shanghai sam

Thank you. This will help me in the future, but not for my immediate problem. The motherboard that went bad is not available, so I replaced it with a different one. If there is a way to merge the PNP ID of the new board into the Windows registry of the mirrored set that will not boot, I would like to know it. As of yet, I am forced to load another drive with Windows 2000 Server to be used as the boot volume and use this mirrored set as secondary.

Thanks again.

This discussion is closed to new replies.