9 replies
by thechas
I usually re-install W98 for this kind of situation.
I suspect that 1 or more key Windows files are missing or corrupt.
The only real problem from re-installing is that you may need to re-install the application programs if the registry is part of the corrupt files.
I would also run scandisk in thorough mode to verify that the HDD is not close to failure.
Chas
by ann777
MSDOS.SYS is probably set incorrectly.
http://www.pccomputernotes.com/tips&tricks/msdsyst&t.htm
If the above fails to help, then yes... rerun setup.exe
by fenaikh
Hi
1. Make sure that the keys Ctrl and F8 are not sticky which makes it always boot to DOS.
2. Reboot and either press Ctrl or F8 key to go to the boot menu screen, then choose Normal or option 1. This hopfully will boot to windows.
start->serach->file or folder> (type) MSDOS.SYS -> right click on that file which is in the root directory of your boot disk say c:\MSDOS.SYS -> from the list menu choose "Properties"
-> click "Change" in the "General TAB" then choose Notepad from the open with list. -> click "OK". -> when you return to the "Properties" unckeck the read only "Attribute" -> click "Apply" then "OK" go back to the "Search Result", then double click the c:\MSDOS.SYS file . under [Options] section change BootMulti=0 to "1" and BootGUI=0 to "1". Save it then exit.
Go back to the search result then right click on c:\MSDOS.SYS from the list menu choose "Properties". -> mark ckeck the read only "Attribute" -> click "Apply" then "OK", then reboot.
Good luck
Mohamed
Win98 doesn't ask to "go to Windows" no matter how badly MSDOS.SYS or other files are messed up. This sounds more like a hold-over from a Win3.1 custom config.
Look at the AUTOEXEC.BAT file and see if there is a line with either ASK or CHOICE. If possible, post it here so I can give you better advice.
Ralph
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending