Discussion Locked

My PC is not booting at all

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

when i turn on my pc i don't found any respnonse and sound , just my screen is flashing.

I remove all card except SVGA , and change memory , SVGA too

Please help me if anyone knows solution.

I will be very thankful of him/her.

Anwer Waseem
Network Administrator

15 replies

by vinnyd

Check the following:

1. Does the Power Supply Fan turn on?

IF no, you may have a dead power supply.

2. When you press the power switch does the keyboard led's flash?

IF no the system board is gone or the processor may be bad!Since you have removed all the cards (I assume that you have also disconnected the floppy drive, hard drive, and Cd-rom as well as any external device that may draw power from the computer) the system board is the culprit.

by stelmos2000

Remove all your cards except for the video card. Plug the monitor cable to the video input. Connect the keyboard and mouse to the PS/2 ports. Plug the power cable and turn the PC on. If you still see the Signal Missing, either move the video card to another PCI slot or replace the video card.

Another thing that you can try is to test the video card on another PC.

by anubhav

1. Try testing The Video card on another machine. If it works, then try installing it into another PCI slot on your Motherboard. if it doesnt work, change your video card.

2. Try booting up with just your video card, mouse, keyboard.
A bad mother board will not flash the Num lock, caps lock and Scroll Lock keys upon booting.

3. Test your memory in another machine or in a RAM tester. If the memory is fine and the video card is fine - Inspect the Ram Slots on your motherboard to see if they are fried.

by mything

Reset all cards, make sure ide cables are snug to mb and harddrive.
Any beeps???

by mark

You need a "POST" card to see if you have activity. The POST code will tell you what is hanging. Usually it's RAM or Video. If you don't get any POST Code activity then it is CPU or MainBoard. You should get POST Code activity even without RAM. I'm assuming you have some indication of power.

by braveh4rt

1. try to check your monitor. is the power LEd is on? usualy if the monitor don't get signal from the vga it's have a yellow color. If it has, the color is green.

2. try to remove your svga and reboot. You should hear a beep, long beep once and a short beep once.
If you hear it, your mb is good.

3. chek you pc power light?>
is it on? and when reboot, do the HDD light is on? if yes, your hdd and power supply is good.

4. check your RAM. Make sure you put it in dimm1. then try to boot.

5. can you access the bios screen ?
if not then your motherboard is doesn't work.
try to switch it with the other one.

thank you..may it help you

by peters

I have had this problem in the past. It is quite possible that the switch for the Power Supply(if it is ATX) could not be making the proper connections. Also try reseating the CPU.

Or the MotherBoard could be shorting out somewhere on the case.

Hope this helps

This discussion is closed to new replies.