Discussion Locked

NAT configured but W98 PCs no net access

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running a W2000 server with a network of 5 W98SE desktops. Nothing complicated, running DHCP & DNS with standard settings. Want to share single modem Internet access. Can?t use ICS as wont run on domain server & consensus seems to be that NAT is more robust.
Following instructions from Microsoft, Tech Republic & various other articles I used the wizard to configure Routing & Remote Access. Selected Internet Connection Server, NAT, & selected my server?s NIC as the internal interface & my Dial Up connection as the external. At this point followed the wizard to make this a Demand-dial interface.
So far so good. In properties of NAT/address assignment I ensured the check box was cleared so that the system should use server DHCP not the?DHCP-light? that?s part of NAT ? this ?cos I don?t want to touch the domain?s DHCP.
Similarly I left the check box in the Name Resolution tab of NAT properties clear as want to use DNS proper.
Result: At the server I get Demand-Dial internet connectivity, at the desktops I get ignored.
From the desktops I can ping the Local Area Connection interface (10.10.1.1) & the internal gateway (10.0.0.18) but I can?t ping the external (Demand dial) interface (e.g. 203.166.0.xxx served by the ISP)
The server is handing out the 10.0.0.x IP set which I believe is one of the permitted sets? From what I can gather I don?t HAVE to have the 192.168.0.x scope in DHCP?
IPconfig on the desktops shows
Host Info: DNS servers 10.10.1.1
Ethernet Adapter Info: IP address 10.0.0.x, Subnet 255.0.0.0 Default gateway BLANK, DHCP server 10.10.1.1, & both WINS servers BLANK. I think I need to configure the desktops to have a Default Gateway IP of the internal gateway (10.0.0.18)? I?ve tried on 2 workstations to add this but winipcfg shows no Default gateway.
Many thanks in advance, I?ve missed something I guess??

3 replies

by d_v ant

You need to configure the default gateway in your dhcp scope. The server should be providing the clients with this info, but isn't.

Hope this helps...

This discussion is closed to new replies.