Question Locked

Net connection for Dell Inspiron 1501 Laptop using Barts Modboot

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to use Barts MODBOOT system to connect an INSPIRON 1501 Laptop (Broadcom NIC B44) to our Network but get the following error:-

Could not find any device
The driver failed to load.
Error loading device driver B44.DOS
Error 7306: The driver failed to initialize.
B44.DOS was not loaded.
Error 7321: Network-card drivers failed to load.

I've used the PCI scanner tool to get the vender and device but I can't get it to work
I think the ndis.pci file is in error and I've tried a few of variations on the below.

ndis.pci:-
;dev 170 added for Dell Inspiron 1501
ret="B44"
ven=14E4 "Broadcom"
dev=170C "Broadcom 440x 10/100 Integrated Controller"

Other files are:-

b44.ini:- (Also commented in and out Bold lines to now avail )

; Protocol.ini section for the Broadcom 440x 10/100 Integrated Controller DOS/OS2 NDIS2 driver
DriverName = "B44$"
; BusNum from 0 to 255
BusNum =8
; DevNum from 0 to 31
DevNum =0
; PortNum or FuncNum from 0 to 7
; PortNum =
FuncNum =0
; LinSpeed can be set to 10, 100, or 1000
; LineSpeed =
; Duplex can be set to half or full. LineSpeed is required when this keyword is used.
; Duplex =
;
; To add more adapter(up to 4) repeat the below entry, where n can be from 1 to 3.
;
;[B44_n]
; DriverName = "B44$"
; BusNum =
; DevNum =
; PortNum =
; FuncNum =
; LineSpeed =
; Duplex =

;Bus 8 (PCI), Device Number 0, Device Function 0

ndis.txt:-
B44 Broadcom 440x 10/100 Ethernet NDIS2 Driver v2.44

I found a similar problem on Google with answer from jeffryk16 but my PCIscan does not show a similar line :-
ID PCI\VEN_14E4&DEV_4401&SUBSYS_80A81043&REV_01\4&3B90381F&0&28F0
although Dell is shown as subsystem

3 replies

by rahouseholder

Go here and download the drivers for this card from Dell. It includes DOS drivers...

by robert.brooks

Can't find your link - but I got the latest B44.dos from Dell. I've made a 'straight' net boot stick that works using the B44 driver. I'm now trying to use Barts method for auto detection of the device. The issue, I believe, is that the .PCI is incorrect so the device can't be found.

This discussion is closed to new replies.