IT Employment

Ask something
Discussion Locked

Network connections

0 helpful
2 replies

by briblank

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been doing networks for a long time....

So I cavalierly set out to install a netware 6 server with 50 user license without doing much homework....

I go the server up and going thought I was looking good so I started to connect win2k clients using MS client software, IP etc...

I started getting these failure to connect messages reflecting some "too many connections" (I know it isn't what I am thinking- I check Monitor and there is maybe 8 connections) including several used up for the server itself-Web etc.) is this something fundamentally wrong or did I miss a setup question somewhere?

Brian

2 replies

by brian m

Microsoft's client for NW doesn't support IP, only IPX. If you want to use the MS client, load IPX on the server. If you want to use IP, then you'll have to install Novell's client.

This discussion is closed to new replies.